RETURN TO                                                                                                           Printer Friendly
    HOME                                                                                                                 Version

CENTRIFUGAL PUMP SHROUD
AND PUMP REPLACEMENT

!WARNING: RISK OF ELECTRIC SHOCK, DISCONNECT POWER PRIOR TO SERVICING
STEP 1  Place the fountain upright with the motor resting on a stable surface.  CAUTION:  Do not allow the unit to fall over as damage may occur.

STEP 2  Remove the water plenum, nozzle assembly and gasket by removing the four 1/4-20 hex head cap screws from the flange of the water plenum.

STEP 3  Remove the four 1/4-20 hex head cap screw that attach the pump to the motor mount.  Remove the pump by pulling upward with a rocking motion to lift pump from the motor.

STEP 4  Remove the shroud and clean all debris from the motor mount and motor shaft.  Inspect the unit for any other damage.

STEP 5  Install new shroud.

STEP 6  Install new pump assembly by aligning the impeller hub to the motor shaft and pushing downward onto the motor shaft.

STEP 7  Align the four pump mounting holes to the four holes of the motor mount and install the four 1/4-20 hex head cap screws and tighten to 50-55 in/lbs.

STEP 8  Reinstall the gasket, water plenum and nozzle assembly.

1-800-821-3177
8100 Paseo
Kansas City, MO  64131
Fax 816-363-2322  sales@airolator.com
Copyright 2007